Poole · Dorset
Misted Glass Repair in Poole
Clear glass again in Poole: replacing blown double glazing units restores the view and a sealed cavity while your existing frames stay in place.
- BH15
- BH14
- BH17
- Guide from £155
Poole: misted double glazing
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
A misted unit is a good opportunity to upgrade an older plain glass unit to one with a low-emissivity coating and gas fill. The new unit reduces heat loss through the glass and keeps the room-side pane warmer, without any change to the frame.
Some services offer to drill the glass, flush the cavity and add a vent instead of replacing the unit. This can improve the look, but it does not restore the original seal, and any gas fill that helped the unit insulate has already been lost. Replacement restores a sealed cavity.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
What you get
- Fitting on packers with drainage slots checked
- Measurement of each failed sealed unit
- Made-to-measure replacement units matching your windows
- Removal of old units and cleaning of rebates
About Poole for this job
- Postcodes covered
- BH15, BH14, BH17 and the surrounding area, including Bournemouth, Ferndown and Christchurch
- Coast
- Poole is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Poole the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 63° and 16.3 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Poole
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your misted glass repair
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Misted Glass Repair in Poole: questions
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Is it worth replacing misted units or should I get new windows?
If the frames are sound, square and the hinges and locks work, replacing only the misted units is usually the more economical option. New windows make more sense if the frames are rotten, warped, draughty or hard to open. The glazier checks the frames at the survey and the quote will say if replacing units is not good value.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Do you cover Poole for misted glass repair?
Yes. We can quote for misted glass repair across Poole and the surrounding Dorset area, including postcode districts BH15, BH14 and BH17, and nearby Bournemouth, Ferndown and Christchurch. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Poole
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.