Kingston upon Thames · Greater London
Misted Glass Repair in Kingston upon Thames
Is there fog between the panes of your windows in Kingston upon Thames? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- KT1
- KT2
- KT3
- KT5
- KT6
- KT9
- Guide from £155
Kingston upon Thames: blown double glazing units
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
What you get
- Survey to confirm the mist is inside the unit
- Fitting on packers with drainage slots checked
- Made-to-measure replacement units matching your windows
- Written quote fixing the price for the specification
About Kingston upon Thames for this job
- Postcodes covered
- KT1, KT2, KT3, KT5, KT6, KT9 and the surrounding area, including Surbiton, New Malden and Twickenham
- Coast
- Kingston upon Thames is well inland, around 46 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Kingston upon Thames the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Kingston upon Thames
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
What you can choose
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Kingston upon Thames: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Is it worth replacing misted units or should I get new windows?
If the frames are sound, square and the hinges and locks work, replacing only the misted units is usually the more economical option. New windows make more sense if the frames are rotten, warped, draughty or hard to open. The glazier checks the frames at the survey and the quote will say if replacing units is not good value.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
Do you cover Kingston upon Thames for misted glass repair?
Yes. We can quote for misted glass repair across Kingston upon Thames and the surrounding Greater London area, including postcode districts KT1, KT2, KT3, KT5 and KT6, and nearby Surbiton, New Malden and Twickenham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Kingston upon Thames
Get a written quote in Kingston upon Thames
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.