Eastleigh · Hampshire
Misted Glass Repair in Eastleigh
Is there fog between the panes of your windows in Eastleigh? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- SO50
- SO53
- Guide from £155
Blown double glazing units for homes and businesses in Eastleigh
Some services offer to drill the glass, flush the cavity and add a vent instead of replacing the unit. This can improve the look, but it does not restore the original seal, and any gas fill that helped the unit insulate has already been lost. Replacement restores a sealed cavity.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
What you get
- Survey to confirm the mist is inside the unit
- Fitting on packers with drainage slots checked
- Measurement of each failed sealed unit
- Made-to-measure replacement units matching your windows
Working in Eastleigh
- Postcodes covered
- SO50, SO53 and the surrounding area, including Southampton, Winchester and Totton
- Coast
- Eastleigh sits roughly 8 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Eastleigh the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 62° and 16.3 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Eastleigh
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Options to choose between
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Misted Glass Repair in Eastleigh: questions
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Is it worth replacing misted units or should I get new windows?
If the frames are sound, square and the hinges and locks work, replacing only the misted units is usually the more economical option. New windows make more sense if the frames are rotten, warped, draughty or hard to open. The glazier checks the frames at the survey and the quote will say if replacing units is not good value.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Do you cover Eastleigh for misted glass repair?
Yes. We can quote for misted glass repair across Eastleigh and the surrounding Hampshire area, including postcode districts SO50 and SO53, and nearby Southampton, Winchester and Totton. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Eastleigh
Misted Glass Repair nearby
Get a written quote in Eastleigh
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.