Gosport · Hampshire
Misted Glass Repair in Gosport
Clear glass again in Gosport: replacing blown double glazing units restores the view and a sealed cavity while your existing frames stay in place.
- PO12
- PO13
- Guide from £155
About blown double glazing units in Gosport
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
What's included
- Written quote fixing the price for the specification
- Removal of old units and cleaning of rebates
- Survey to confirm the mist is inside the unit
- Fitting on packers with drainage slots checked
About Gosport for this job
- Postcodes covered
- PO12, PO13 and the surrounding area, including Portsmouth, Fareham and Ryde
- Coast
- Gosport is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Gosport the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 63° and 16.3 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Gosport
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your misted glass repair
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Misted Glass Repair in Gosport: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Do you cover Gosport for misted glass repair?
Yes. We can quote for misted glass repair across Gosport and the surrounding Hampshire area, including postcode districts PO12 and PO13, and nearby Portsmouth, Fareham and Ryde. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Gosport
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.