Deal · Kent
Misted Glass Repair in Deal
Our glaziers cover Deal for misted window repairs, checking frames and drainage at the survey so the new sealed units are fitted correctly.
- CT14
- Guide from £155
Misted double glazing in Deal
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
Some services offer to drill the glass, flush the cavity and add a vent instead of replacing the unit. This can improve the look, but it does not restore the original seal, and any gas fill that helped the unit insulate has already been lost. Replacement restores a sealed cavity.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
What a typical job includes
- Written quote fixing the price for the specification
- Fitting on packers with drainage slots checked
- Survey to confirm the mist is inside the unit
- Made-to-measure replacement units matching your windows
Deal at a glance
- Postcodes covered
- CT14 and the surrounding area, including Dover, Ramsgate and Broadstairs
- Coast
- Deal is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Deal the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Deal
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Misted Glass Repair in Deal: questions
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Is it worth replacing misted units or should I get new windows?
If the frames are sound, square and the hinges and locks work, replacing only the misted units is usually the more economical option. New windows make more sense if the frames are rotten, warped, draughty or hard to open. The glazier checks the frames at the survey and the quote will say if replacing units is not good value.
Do you cover Deal for misted glass repair?
Yes. We can quote for misted glass repair across Deal and the surrounding Kent area, including postcode districts CT14, and nearby Dover, Ramsgate and Broadstairs. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Deal
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.