Bath · Somerset
Misted Glass Repair in Bath
Is there fog between the panes of your windows in Bath? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- BA1
- BA2
- Guide from £155
Condensation between panes in Bath: what to know
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Replacing a misted unit is usually a short job per window once the new unit has been made. The old unit is lifted out, the frame rebate and drainage cleaned, and the new unit set on packers so the weight is supported and any opening sash stays square.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
The price of replacing misted units depends on the size of each unit, the glass specification, any bars or decorative features, how many units are done together, and access. Several units on one visit usually cost less each than separate visits for single windows.
What's included
- Measurement of each failed sealed unit
- Survey to confirm the mist is inside the unit
- Fitting on packers with drainage slots checked
- Removal of old units and cleaning of rebates
Local details for Bath
- Postcodes covered
- BA1, BA2 and the surrounding area, including Keynsham, Trowbridge and Kingswood
- Coast
- Bath is well inland, around 29 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Bath the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Bath
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Options to choose between
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Misted Glass Repair in Bath: questions
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
Do you cover Bath for misted glass repair?
Yes. We can quote for misted glass repair across Bath and the surrounding Somerset area, including postcode districts BA1 and BA2, and nearby Keynsham, Trowbridge and Kingswood. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Bath
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.