Staines · Surrey
Misted Glass Repair in Staines
We cover Staines and Surrey for misted double glazing repair, replacing blown sealed units in uPVC, aluminium, timber and composite frames.
- TW15
- TW16
- TW17
- TW18
- Guide from £155
Staines: foggy window replacement
If the misted unit is in a door, beside a door or low down near the floor, the replacement should be safety glass. In England, Approved Document K sets out these critical locations, and the replacement unit should meet them even if the original glass did not.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Check the paperwork for your windows before booking. Many sealed units come with a manufacturer guarantee against misting, and if your windows are still covered, the original installer or manufacturer may be responsible for replacing the failed unit under its terms.
What's included
- Removal of old units and cleaning of rebates
- Made-to-measure replacement units matching your windows
- Written quote fixing the price for the specification
- Survey to confirm the mist is inside the unit
About Staines for this job
- Postcodes covered
- TW15, TW16, TW17, TW18 and the surrounding area, including Egham, Ashford (Surrey) and Feltham
- Coast
- Staines is well inland, around 60 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Staines the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Staines
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Choosing your misted glass repair
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Misted Glass Repair in Staines: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Do you cover Staines for misted glass repair?
Yes. We can quote for misted glass repair across Staines and the surrounding Surrey area, including postcode districts TW15, TW16, TW17 and TW18, and nearby Egham, Ashford (Surrey) and Feltham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Staines
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.