Salisbury · Wiltshire
Misted Glass Repair in Salisbury
We cover Salisbury and Wiltshire for misted double glazing repair, replacing blown sealed units in uPVC, aluminium, timber and composite frames.
- SP1
- SP2
- Guide from £155
Misted window repair for homes and businesses in Salisbury
The price of replacing misted units depends on the size of each unit, the glass specification, any bars or decorative features, how many units are done together, and access. Several units on one visit usually cost less each than separate visits for single windows.
Once the seal has failed, any argon or other insulating gas in the cavity has escaped and been replaced by ordinary damp air. The unit insulates less well than when it was new, and moisture inside can gradually leave deposits that dull the glass.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
A misted unit is a good opportunity to upgrade an older plain glass unit to one with a low-emissivity coating and gas fill. The new unit reduces heat loss through the glass and keeps the room-side pane warmer, without any change to the frame.
Included as standard
- Removal of old units and cleaning of rebates
- Written quote fixing the price for the specification
- Made-to-measure replacement units matching your windows
- Measurement of each failed sealed unit
Salisbury at a glance
- Postcodes covered
- SP1, SP2 and the surrounding area, including Andover, Totton and Ferndown
- Coast
- Salisbury is well inland, around 32 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Salisbury the midwinter sun reaches about 16° above the horizon at noon, with roughly 7.7 hours of daylight, rising to about 62° and 16.3 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Salisbury
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Misted Glass Repair in Salisbury: questions
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Can you clean the inside of a misted double glazing unit?
Not without breaking the seal. Some firms drill the glass, flush the cavity and fit a small vent, which can clear the mist for a while. It does not restore an airtight seal or gas fill, and white staining may not fully clear. Replacing the unit is the reliable way to restore a clear, sealed cavity.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Do you cover Salisbury for misted glass repair?
Yes. We can quote for misted glass repair across Salisbury and the surrounding Wiltshire area, including postcode districts SP1 and SP2, and nearby Andover, Totton and Ferndown. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Salisbury
Misted Glass Repair nearby
Get a written quote in Salisbury
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.