Enniskillen · County Fermanagh
Roof Lanterns in Enniskillen
Old polycarbonate lanterns in Enniskillen that leak, rattle or have yellowed can usually be replaced with a double glazed aluminium lantern on a sound upstand.
- BT74
- Guide from £1,095
Opening skylights across Enniskillen
Warm, moist air rises and collects in a roof lantern, so condensation can form on cold winter mornings, especially over kitchens and bathrooms. Thermally broken frames, warm-edge spacers and good room ventilation reduce it, and opening vents in the lantern can release warm air in summer.
Roof lanterns are made in rectangular, square and octagonal shapes, with hipped or gable ends. Frames are usually powder-coated aluminium, often grey or black outside and white inside. Manufacturing lead times depend on size and colour, and the expected timescale is confirmed in writing with the quote.
Cutting a new opening for a roof lantern or skylight usually means trimming joists or rafters, so the roof can carry the load around the hole. Building regulations approval is generally needed for a new rooflight, covering structure, energy performance and, near a boundary, fire performance.
Old polycarbonate or single glazed roof lanterns can be replaced with double glazed aluminium lanterns on the existing upstand, if the upstand is sound, level and the right size. Upstands that are rotten, uninsulated or out of level should be rebuilt first, which the survey identifies.
What a typical job includes
- Written guarantee terms and manufacturer documentation
- Removal and disposal of an old lantern or skylight
- Made-to-measure aluminium roof lantern or framed skylight
- Survey of the roof, opening, upstand and drainage
Working in Enniskillen
- Postcodes covered
- BT74 and the surrounding area, including Irvinestown, Lisnaskea and Omagh
- Coast
- Enniskillen is well inland, around 43 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Enniskillen the midwinter sun reaches about 12° above the horizon at noon, with roughly 7.0 hours of daylight, rising to about 59° and 17.0 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
- Access and setting
- Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
- Rules in Northern Ireland
- Technical Booklet V covers safety glazing in Northern Ireland, including glass in and around doors and low-level glazing where people could walk into it.
Guide prices in Enniskillen
| Typical job | Guide price inc VAT |
|---|---|
| Lantern 1500 × 1000 mm, fitted to a kerb | £1,395 – £1,795 |
| Lantern 2000 × 1000 mm | £1,695 – £2,095 |
| Lantern 3000 × 1500 mm | £2,795 – £3,695 |
| Flat glass rooflight 1000 × 1000 mm | £1,095 – £1,395 |
Get a guide price for your size
Replacement windows on houses in Northern Ireland are often permitted development, but conservation areas and listed buildings can need consent. Check with the council's planning office.
Specification choices
Flat framed skylight
A low-profile framed rooflight on a flat roof upstand, fixed or opening, for bathrooms, landings and smaller rooms.
Opening vents
Manual or electric vents in the lantern or skylight, with optional rain sensors that close them automatically in wet weather.
Rectangular hipped lantern
A long ridge with hipped ends, suiting most rectangular extensions and kitchens, sized to the opening and the room below.
Roof Lanterns in Enniskillen: questions
Can I replace my old polycarbonate roof lantern with glass?
Yes, in most cases. A glass lantern is heavier than polycarbonate, so the upstand and roof structure must be able to carry it. If the upstand is sound, level and the right size, a new aluminium lantern can usually sit on it. If not, the upstand is rebuilt first, which the survey will identify.
Why does my roof lantern get condensation?
Condensation forms when warm, moist air from cooking, bathing or drying clothes meets the colder glass and frames at high level. Older single glazed or non thermally broken lanterns suffer most. Thermally broken frames, warm-edge spacers, extractor fans and opening vents reduce it. Some condensation on very cold mornings is normal and clears as the room warms.
How long does it take to fit a roof lantern?
Fitting a roof lantern on a prepared upstand usually takes a day or less for a typical size, longer for large or complex shapes. The lantern is made to order first, and the lead time depends on its size, shape and colour. Building or rebuilding an upstand is separate roofing work that comes before fitting.
Should the inner glass in a roof lantern be laminated?
Laminated inner glass is the safer choice and is recommended by the Rooflight Association. If a laminated pane breaks, the interlayer holds the pieces together, so glass is far less likely to fall into the room below. This matters most over kitchens, dining tables, stairs and seating, and it is offered as a standard option.
Do you cover Enniskillen for roof lanterns?
Yes. We can quote for roof lanterns across Enniskillen and the surrounding County Fermanagh area, including postcode districts BT74, and nearby Irvinestown, Lisnaskea and Omagh. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Enniskillen
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.