Fulham · Greater London
Roof Lanterns in Fulham
Our glaziers fit roof lanterns across Fulham, glazing and sealing each unit onto its upstand and explaining any building regulations approval the work needs.
- SW6
- SW10
- SW5
- Guide from £1,095
Aluminium roof lantern for homes and businesses in Fulham
A roof lantern is assembled from an aluminium ridge, hip bars and glazing bars that hold sealed glass units on each pitch. It sits on an upstand built around the roof opening. The upstand should be level, weathered into the roof covering and insulated, because a poor upstand causes most leaks and cold spots.
In England, Approved Document L sets a limiting U-value of 2.2 W/m²K for rooflights, calculated in the horizontal position, for both new and existing homes. A kerb or upstand built on site should achieve 0.35 W/m²K or better. Ask for the lantern's declared horizontal U-value, not a vertical figure.
Roof lanterns are made in rectangular, square and octagonal shapes, with hipped or gable ends. Frames are usually powder-coated aluminium, often grey or black outside and white inside. Manufacturing lead times depend on size and colour, and the expected timescale is confirmed in writing with the quote.
Roof lanterns are not designed to be walked on, so never stand or lean on the glass or bars. Cleaning and inspection should be done from safe access at the edge of the roof. Keep leaves and debris away from the upstand and roof outlets so water drains freely.
Included as standard
- Written guarantee terms and manufacturer documentation
- Made-to-measure aluminium roof lantern or framed skylight
- Sealed double glazed units with laminated inner pane options
- Survey of the roof, opening, upstand and drainage
Fulham at a glance
- Postcodes covered
- SW6, SW10, SW5 and the surrounding area, including Hammersmith, Chelsea and Kensington
- Coast
- Fulham is well inland, around 39 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Fulham the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
- Access and setting
- Getting a large lantern onto a terraced flat roof may mean carrying it through the house or lifting it over neighbouring property, so access is planned at survey. Lanterns near a boundary raise fire performance questions, and conservation areas may restrict raised glazing.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Fulham
| Typical job | Guide price inc VAT |
|---|---|
| Lantern 1500 × 1000 mm, fitted to a kerb | £1,395 – £1,795 |
| Lantern 2000 × 1000 mm | £1,695 – £2,095 |
| Lantern 3000 × 1500 mm | £2,795 – £3,695 |
| Flat glass rooflight 1000 × 1000 mm | £1,095 – £1,395 |
Get a guide price for your size
If the glass sits in a fire-resisting door or screen, such as a flat entrance door or a commercial corridor screen, it must be replaced with fire-rated glazing tested as part of that system. Ordinary toughened glass is not a substitute.
Options to choose between
Opening vents
Manual or electric vents in the lantern or skylight, with optional rain sensors that close them automatically in wet weather.
Rectangular hipped lantern
A long ridge with hipped ends, suiting most rectangular extensions and kitchens, sized to the opening and the room below.
Solar-control glass
Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.
Roof Lanterns in Fulham: questions
Do I need planning permission for a roof lantern?
Sometimes. In England, rooflights on a house are usually permitted development if they project no more than 150mm above the roof plane and are no higher than the highest part of the roof. Raised lanterns often exceed that, and flats, listed buildings and conservation areas have extra controls, so check with your council first.
Should the inner glass in a roof lantern be laminated?
Laminated inner glass is the safer choice and is recommended by the Rooflight Association. If a laminated pane breaks, the interlayer holds the pieces together, so glass is far less likely to fall into the room below. This matters most over kitchens, dining tables, stairs and seating, and it is offered as a standard option.
How do I clean a roof lantern?
Self-cleaning coated glass lets rain lift most dirt, but a rinse with clean water in long dry spells helps. Clean from a safe position at the roof edge or from a suitable platform, never by standing on the lantern. Wipe the inside glass with mild soapy water, and keep leaves clear of the upstand and roof outlets.
Why does my roof lantern get condensation?
Condensation forms when warm, moist air from cooking, bathing or drying clothes meets the colder glass and frames at high level. Older single glazed or non thermally broken lanterns suffer most. Thermally broken frames, warm-edge spacers, extractor fans and opening vents reduce it. Some condensation on very cold mornings is normal and clears as the room warms.
Do you cover Fulham for roof lanterns?
Yes. We can quote for roof lanterns across Fulham and the surrounding Greater London area, including postcode districts SW6, SW10 and SW5, and nearby Hammersmith, Chelsea and Kensington. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Fulham
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.