Arbroath · Angus & Dundee
Secondary Glazing in Arbroath
Secondary glazing in Arbroath keeps your original windows in place while adding a slim inner window to cut noise, draughts and heat loss.
- DD11
- Guide from £465
Secondary glazing listed buildings in Arbroath
For noise reduction, the size of the air gap between the original window and the secondary unit matters a great deal, and a wider cavity generally performs better. Acoustic laminated glass and well-sealed frames improve results further, especially against traffic, rail and aircraft noise.
Secondary glazing leaves the original window untouched and fits a second, independent window inside it. The air gap between the two works with the glass to reduce noise and heat loss. In most cases the installation can be taken out later without damaging the historic window or reveal.
Secondary glazing can also add security, because an intruder would have to break through two separate windows. Laminated glass and locking catches on the secondary unit add further resistance, which is useful for ground-floor and basement windows in period properties.
Owners of listed buildings should seek listed building consent before installing secondary glazing, as the requirements depend on the building and the council. Secondary glazing is often seen as a minimal, reversible change, but carrying out works that need consent without it is a criminal offence.
What's included
- Removal of packaging and cleaning of new glass
- Fitting, sealing and checking every opening panel
- Written quote fixing the price for the specification
- Advice on opening style, glass and fire escape
About Arbroath for this job
- Postcodes covered
- DD11 and the surrounding area, including Carnoustie, Montrose and Forfar
- Coast
- Arbroath is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Coastal properties often have older windows exposed to wind-driven rain and draughts. Secondary glazing adds a sealed inner layer that reduces draughts and cold, while the original window keeps out the weather and its condition is protected from inside.
- Daylight and sun
- In Arbroath the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.5 hours of daylight, rising to about 57° and 17.5 hours in midsummer. Secondary glazing adds an extra layer of glass, which slightly reduces daylight. Low-iron or clear low-E glass keeps light loss to a minimum, while on sunny elevations solar control glass can help reduce overheating in rooms with large windows.
- Access and setting
- Rural cottages and period homes often have single-glazed timber windows that cannot easily be replaced. Secondary glazing reduces draughts and heat loss in exposed locations, and the surveyor allows for uneven reveals and older plaster when fixing frames.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Arbroath
| Typical job | Guide price inc VAT |
|---|---|
| Slider, 900 × 1200 mm | £465 – £595 |
| Slider, 1200 × 1600 mm | £665 – £845 |
| Acoustic glass, 1000 × 1400 mm | £675 – £865 |
Get a guide price for your size
Listed buildings in Scotland need listed building consent for most changes to historic windows; Historic Environment Scotland publishes guidance on traditional windows.
Specification choices
Hinged casement
Panels open inwards like a door, giving full access to the original window, and can be chosen for escape windows.
Acoustic laminated glass
Laminated glass with a sound-dampening interlayer, combined with a generous cavity, for properties affected by traffic, rail or aircraft noise.
Low-E glass
Coated glass that reflects heat back into the room, improving insulation when the original window is single glazed.
Secondary Glazing in Arbroath: questions
Will secondary glazing cause condensation?
It can, if the original window is sealed tighter than the secondary unit, because warm, moist room air then gets trapped in the cavity. The secondary unit should be the more airtight of the two, and the original window should not be fully sealed. Opening the secondary panel lets room air into the cavity, so close it again afterwards.
Which opening style should I choose?
Choose based on how you use the window. Vertical sliders suit sash windows and keep meeting rails aligned. Horizontal sliders suit wide windows. Hinged panels give full access for cleaning and escape. Lift-out and fixed panels suit windows that are rarely or never opened, and give the tightest seal for noise.
Do I need permission for secondary glazing on a listed building?
You should seek listed building consent from the council's planning department before installing secondary glazing on a listed building. Secondary glazing is often seen as a reversible, low-impact change, but consent requirements depend on the building. Carrying out works that need consent without it is a criminal offence. If your home is not listed but is in a conservation area, check with the council if you are unsure.
Is secondary glazing suitable for rented homes and flats?
Yes. Secondary glazing is fitted inside, so it often avoids the external changes that leases, freeholders or planning rules restrict. It can be removed later with limited making good. Leaseholders should still check their lease for any rules on internal alterations, and landlords should check escape routes are not affected.
Do you cover Arbroath for secondary glazing?
Yes. We can quote for secondary glazing across Arbroath and the surrounding Angus & Dundee area, including postcode districts DD11, and nearby Carnoustie, Montrose and Forfar. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Arbroath
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.