Dundee · Angus & Dundee
Safety Glass in Dundee
Need a glass panel made to measure in Dundee? Our glaziers confirm the thickness, edge finish and holes before the glass is toughened.
- DD1
- DD2
- DD3
- DD4
- DD5
- Guide from £55
Safety glass for doors in Dundee: what to know
Toughened glass is ordinary float glass that has been cut to size, heated and then cooled quickly with jets of air. This leaves the surfaces in compression, making it several times stronger than untreated glass of the same thickness. When it does break, it crumbles into small, relatively blunt pieces.
The price of safety glass depends on its size, thickness, whether it is toughened or laminated, the edge finish, the number of holes and cut-outs, any shapes or curves, and whether it is supplied only or fitted. Low-iron or tinted glass costs more than clear float.
Safety glass in a building should carry a permanent mark, usually in a corner, that stays visible after fitting. It names the maker or supplier and the standard, such as BS EN 12150 for toughened glass. The mark is how a buyer or inspector can confirm what was fitted.
When measuring for a replacement panel, measure the opening or old glass in at least two places for width and height, and note the thickness. For anything with holes, curves or angled corners, a hardboard or card template gives the most reliable result.
What you get
- Permanent safety marking on building glass
- Measurement or templating of the glass panel
- Delivery or fitting by our glaziers
- Glass cut, edge-worked and drilled before toughening
Working in Dundee
- Postcodes covered
- DD1, DD2, DD3, DD4, DD5 and the surrounding area, including Carnoustie, St Andrews and Forfar
- Coast
- Dundee is about 1 km from the coast or a tidal estuary, so salt air and wind-driven rain are worth planning for. Near the coast, salt spray can mark exposed glass edges and corrode metal fixings. Polished edges and sealed laminated edges cope better outdoors, and stainless steel clamps and hinges are worth specifying for external safety glass panels and screens.
- Daylight and sun
- In Dundee the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.6 hours of daylight, rising to about 57° and 17.4 hours in midsummer. Strong sun on large glass panels can cause glare and fade furniture behind them. Tinted, solar control or low-iron toughened glass each change how much light, heat and colour come through, so orientation is worth considering when choosing.
- Access and setting
- In flats and city buildings, large panels of safety glass may need to fit through narrow stairs, lifts and doorways. Measuring access routes at the survey avoids problems, and laminated glass suits ground-floor doors and screens facing the street.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Dundee
| Typical job | Guide price inc VAT |
|---|---|
| 6 mm toughened panel, 800 × 600 mm | £55 – £75 |
| 10 mm toughened panel, 1000 × 2000 mm | £325 – £415 |
| Glass tabletop or shelf, 1200 × 600 mm, 8 mm | £135 – £165 |
| 6.4 mm laminated panel, 900 × 900 mm | £115 – £145 |
Get a guide price for your size
Security standards for doors and windows apply to new homes in Scotland; for replacements, PAS 24 products are a sensible choice.
Choosing your safety glass
Satin or obscure finish
Acid-etched or patterned glass for privacy in doors and screens, toughened or laminated to meet safety requirements.
Toughened laminated glass
Toughened sheets laminated together, combining strength with post-breakage retention, often used for frameless panels and higher-load applications.
Heat soak testing
An extra heat test after toughening that reduces the risk of spontaneous breakage from nickel sulphide inclusions in the glass.
Safety Glass in Dundee: questions
How do I know if my glass is safety glass?
Look for a permanent mark etched or printed in a corner of the pane. It should name the maker or supplier and the standard, such as BS EN 12150 for toughened glass, or show a BS EN 12600 class. Older glass may have no mark. If you are unsure, a glazier can check and advise.
Should I choose a polished or arrised edge?
Choose polished edges where the edge will be seen or touched, such as tabletops, shelves and frameless panels, because they are smooth and look neat. Arrised edges are lightly sanded to remove sharpness and are fine where the edge sits hidden in a frame. Bevelled edges are decorative and suit mirrors and some tabletops.
What is the difference between toughened and laminated glass?
Toughened glass is heat treated so it is stronger and, if broken, crumbles into small, relatively blunt pieces, leaving the opening empty. Laminated glass is sheets bonded to an interlayer, so when it breaks the pieces stay stuck in place. Both can be safety glass. Laminated is preferred where falling glass or an open hole would be a hazard.
Is laminated glass better for security?
Laminated glass usually gives better security than toughened glass of similar thickness, because the interlayer holds the glass together after it cracks, so making a hole takes more effort. Thicker interlayers and multi-layer laminates give more resistance. For ground-floor windows, shopfronts and doors, laminated glass is often chosen for this reason.
Do you cover Dundee for safety glass?
Yes. We can quote for safety glass across Dundee and the surrounding Angus & Dundee area, including postcode districts DD1, DD2, DD3, DD4 and DD5, and nearby Carnoustie, St Andrews and Forfar. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Dundee
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.