South Yorkshire · England
Bespoke Mirrors in South Yorkshire
Our glaziers fit bespoke mirrors in South Yorkshire for homes and businesses, including tinted, antique-effect and bevelled mirrors cut around sockets and fitted furniture.
- Guide from £205
- 7 towns covered
- Postcode areas DN, S
Made to measure mirrors across South Yorkshire
A safety-backed mirror has a film bonded across its back that holds the pieces together if the glass breaks, so fragments stay on the backing instead of falling or scattering. Some backing films are classified for impact under BS EN 12600, and the film is applied before fitting.
A bonded mirror follows the surface behind it, so an uneven wall can bend the reflection. We check flatness at survey, and on uneven plaster or stone walls the mirror may need a flat backing board or the wall levelling first to avoid a wavy, distorted image.
Mirrors must be bonded with an adhesive made to be compatible with mirror backing. Some general-purpose adhesives and acidic sealants can attack the protective coatings and the silver, causing dark patches that spread from behind. We only use mirror-compatible products.
Large mirrors are usually fixed with mirror adhesive and supported at the base by a slim channel or clips while the adhesive cures and afterwards. Smaller mirrors can be screw-fixed through drilled holes with decorative caps, which also lets them be removed later.
Towns we cover for bespoke mirrors in South Yorkshire
Choose your town for local details, nearby areas and the postcode districts we cover.
What applies in South Yorkshire
Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
South Yorkshire is inland, around 35 km from the nearest coast at its closest point, so salt exposure is rarely a factor.
Large mirrors for flats, salons and gyms often have to travel through narrow stairwells and small lifts, so walls may be covered in several panels with planned joints. Loading limits and building working hours can affect fitting times.
Guide prices
| Typical job | Guide price inc VAT |
|---|---|
| Polished mirror, 1200 × 900 mm | £205 – £265 |
| Safety-backed mirror, 1800 × 1000 mm | £365 – £465 |
| Gym mirror wall, 4000 × 2000 mm | £995 – £1,295 |
Choosing your bespoke mirrors
Clear silver mirror
Standard silver-coated float glass mirror, cut to size, suited to most rooms, wardrobes and wall mirrors where a true, neutral reflection is wanted.
Tinted mirror
Grey or bronze tinted mirror that softens the reflection and adds warmth or depth, often used as a feature wall or in hospitality spaces.
Antique-effect mirror
Mirror with a deliberately aged, mottled finish, giving a vintage look for feature walls, alcoves and period-style rooms.
Low-iron mirror
Mirror made on low-iron glass, which reduces the slight green cast of standard glass for a brighter, more colour-accurate reflection.
Bespoke Mirrors in South Yorkshire: questions
Can I have a bespoke mirror in a bathroom?
Yes, provided the room is well ventilated and the mirror is protected from standing water. We use mirror that meets the relevant standard for internal use, bond it with a compatible adhesive and keep edges away from splashes where possible. A heated demister pad can keep part of the mirror clear, wired in by a qualified electrician.
Why do mirrors go black around the edges?
Black edges are corrosion of the silver layer behind the glass, usually caused by moisture or cleaning fluid getting into the edges, or by an adhesive that reacts with the backing. Bathrooms are especially at risk because of steam. The damage cannot be reversed, so the mirror needs replacing, ideally with better edge protection and a compatible adhesive.
Can a large mirror be fixed to plasterboard?
Often, yes, but it depends on the board, its fixings and the surface finish. Adhesive grips the paint or plaster layer, so flaky paint or weak skim can let go under the weight. We check the wall at survey and may add a base channel, mechanical fixings into studs, or a backing board to spread the load.
How is a large mirror fixed to the wall?
Large mirrors are usually bonded with an adhesive made for mirror backing and supported along the bottom edge by a slim channel or clips. The support carries the weight while the adhesive cures and adds security afterwards. Smaller mirrors can be screw-fixed through drilled holes with decorative caps, which makes them easier to remove later.
Which parts of South Yorkshire do you cover for bespoke mirrors?
We cover the whole of South Yorkshire, including Sheffield, Rotherham, Doncaster, Barnsley and Chapeltown, and postcode areas DN, S. Building rules for bespoke mirrors here follow the regulations for England. Enter your postcode on the quote form and we will confirm cover; then a glazier will arrange a free survey before giving you a written quote.
Other glazing services in South Yorkshire
- Replacement Glass in South Yorkshire
- Misted Glass Repair in South Yorkshire
- Emergency Glazing in South Yorkshire
- Safety Glass in South Yorkshire
- Window Repairs in South Yorkshire
- Window Film in South Yorkshire
- uPVC Windows in South Yorkshire
- Aluminium Windows in South Yorkshire
- Sash Windows in South Yorkshire
- Composite Doors in South Yorkshire
- Bifold Doors in South Yorkshire
- Sliding Doors in South Yorkshire
- Secondary Glazing in South Yorkshire
- Roof Lanterns in South Yorkshire
- Glass Balustrades in South Yorkshire
- Frameless Glass in South Yorkshire
- Shower Screens in South Yorkshire
- Glass Splashbacks in South Yorkshire
- Glass Roofs in South Yorkshire
- Shopfront Glazing in South Yorkshire
- Curtain Walling in South Yorkshire
- Glass Partitions in South Yorkshire
- Property Glazing in South Yorkshire
All glazing in South Yorkshire · Bespoke Mirrors across the UK
Get a written quote in South Yorkshire
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.