Leatherhead · Surrey
Curtain Walling in Leatherhead
Planning a glazed facade in Leatherhead? Our glaziers can survey the building and quote for stick or unitised curtain walling specified for its height, exposure and energy needs.
- KT21
- KT22
- Guide from £455 per m²
Curtain wall glass replacement across Leatherhead
Under the energy rules for new work in England, curtain walling performance is assessed for the whole system, including frames and opaque infill panels, not just the glass. Solar gain through the glass is also considered, so the glass choice balances heat loss, overheating and daylight.
A unitised system arrives as storey-height panels assembled and glazed in a factory, which are lifted into place and interlocked. Fewer joints are made on site, which can reduce the risk of air and water leaks from site workmanship, but cranage and lead times need careful planning.
Wind load on a facade rises with height, exposure and building shape, and it decides the mullion size, bracket design and glass thickness. Calculations for the specific site are part of the design, so a system suited to a sheltered ground-floor screen may not suit an exposed upper storey.
Curtain walling needs planned upkeep. Clean frames and glass regularly, keep drainage outlets clear, and inspect gaskets, seals and fixings for shrinkage, gaps or corrosion. Failed or misted sealed units can usually be replaced individually without removing the surrounding framing.
What you get
- Supply and installation of framing, glass and panels
- Final inspection, clean and maintenance guidance
- System selection and glass specification for the building
- Survey of openings, supporting structure and access
Working in Leatherhead
- Postcodes covered
- KT21, KT22 and the surrounding area, including Epsom, Ewell and Esher
- Coast
- Leatherhead is well inland, around 52 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Leatherhead the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Large glazed facades bring in plenty of daylight but also solar gain and glare, especially on south and west elevations. Solar control glass, shading and blinds are balanced against light transmission so interiors stay bright without overheating.
- Access and setting
- Commercial buildings on open rural or upland sites can face high wind exposure and driving rain, which affect frame sizes, glass thickness and sealing details. Longer delivery routes for large glass units also need planning in advance.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Leatherhead
| Typical job | Guide price inc VAT |
|---|---|
| Curtain walling, per m² (stick system) | £455 – £795 |
| Curtain walling, per m² (unitised) | £545 – £955 |
Get a guide price for your size
Replacing windows and doors with similar ones is usually permitted development for houses in England. Flats, listed buildings and homes in conservation areas or covered by an Article 4 direction can need permission, so check with the council first.
Specification choices
Solar control glass
Coated glass that limits solar heat gain on sunny elevations while keeping good daylight, reducing overheating and glare inside.
Stick curtain wall
Mullions and transoms assembled on site with glass and panels fitted afterwards, suited to low-rise buildings, entrances and ground-floor screens.
Unitised curtain wall
Factory-assembled, pre-glazed storey-height panels lifted into place, reducing site joints and work at height on taller or tight sites.
Curtain Walling in Leatherhead: questions
What glass is used in curtain walling?
Curtain walling normally uses sealed double or triple glazed units, with toughened or laminated panes chosen for safety, security and wind load. Coatings control heat loss and solar gain, and heat-soaked toughened glass is often specified for upper levels. Where fire resistance is needed, a tested fire-resistant glazing system is used instead of standard glass.
Do glazed screens in offices and entrances need markings?
Large areas of clear glass that people could walk into need to be made visible. In England, the guidance for buildings other than dwellings puts manifestation at 850–1000mm and 1400–1600mm above the floor, and workplace rules across Great Britain require glass to be marked where needed for safety. Frosted bands or logos can meet this.
Can a single broken glass unit in a curtain wall be replaced?
Usually, yes. In capped systems the cap and pressure plate are removed to release the glass, and a new unit is fitted and resealed. Structurally bonded glass needs the new unit bonding to its carrier, which takes more preparation. Height and access drive much of the work, so we survey the unit and access before quoting.
How should curtain walling be maintained?
Curtain walling should be cleaned regularly and inspected at planned intervals. Check that drainage outlets are clear, gaskets have not shrunk or slipped, sealant joints are intact and fixings show no corrosion. Address misted or cracked units early. A simple maintenance schedule kept with the building records helps facilities teams spot problems before they become leaks.
Do you cover Leatherhead for curtain walling?
Yes. We can quote for curtain walling across Leatherhead and the surrounding Surrey area, including postcode districts KT21 and KT22, and nearby Epsom, Ewell and Esher. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Leatherhead
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.