Putney · Greater London
Misted Glass Repair in Putney
Clear glass again in Putney: replacing blown double glazing units restores the view and a sealed cavity while your existing frames stay in place.
- SW15
- SW6
- SW18
- Guide from £155
Blown double glazing units for homes and businesses in Putney
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
The price of replacing misted units depends on the size of each unit, the glass specification, any bars or decorative features, how many units are done together, and access. Several units on one visit usually cost less each than separate visits for single windows.
A misted unit is a good opportunity to upgrade an older plain glass unit to one with a low-emissivity coating and gas fill. The new unit reduces heat loss through the glass and keeps the room-side pane warmer, without any change to the frame.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
What you get
- Measurement of each failed sealed unit
- Made-to-measure replacement units matching your windows
- Survey to confirm the mist is inside the unit
- Fitting on packers with drainage slots checked
Putney at a glance
- Postcodes covered
- SW15, SW6, SW18 and the surrounding area, including Wandsworth, Barnes and Fulham
- Coast
- Putney is well inland, around 40 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Putney the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- In flats and terraced streets, replacing misted units often means planning access, parking and carrying units up stairs. Upper-floor windows may need to be done from inside, and conservation areas may require matching bars or glass patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Putney
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Options to choose between
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Misted Glass Repair in Putney: questions
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
How much does it cost to replace a misted sealed unit?
The cost depends on the size of the unit, the glass type, any Georgian bars, leaded or obscure features, how many units are done together, and access to the window. Larger units, safety glass and upper-floor windows cost more. See the guide prices for typical sizes, then get a written quote for your exact windows.
Will a new unit match my other windows?
It can. The glazier records the unit thickness, spacer bar colour, any Georgian bars or leaded designs, and the obscure glass pattern if there is one. Most details can be matched closely. If an obscure pattern has been discontinued, the quote offers the closest available alternative so you can decide before anything is ordered.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Do you cover Putney for misted glass repair?
Yes. We can quote for misted glass repair across Putney and the surrounding Greater London area, including postcode districts SW15, SW6 and SW18, and nearby Wandsworth, Barnes and Fulham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Putney
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.