Aldershot · Hampshire
Misted Glass Repair in Aldershot
Misted panes in Aldershot can usually be fixed by swapping the sealed unit alone, keeping your existing frames and avoiding the cost of new windows.
- GU11
- Guide from £155
Blown double glazing units in Aldershot: what to know
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
If the misted unit is in a door, beside a door or low down near the floor, the replacement should be safety glass. In England, Approved Document K sets out these critical locations, and the replacement unit should meet them even if the original glass did not.
Once the seal has failed, any argon or other insulating gas in the cavity has escaped and been replaced by ordinary damp air. The unit insulates less well than when it was new, and moisture inside can gradually leave deposits that dull the glass.
A misted unit is a good opportunity to upgrade an older plain glass unit to one with a low-emissivity coating and gas fill. The new unit reduces heat loss through the glass and keeps the room-side pane warmer, without any change to the frame.
What you get
- Survey to confirm the mist is inside the unit
- Measurement of each failed sealed unit
- Removal of old units and cleaning of rebates
- Written quote fixing the price for the specification
Aldershot at a glance
- Postcodes covered
- GU11 and the surrounding area, including Farnham, Farnborough and Fleet
- Coast
- Aldershot is well inland, around 46 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Aldershot the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Aldershot
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Options to choose between
Laminated safety unit
A unit with laminated glass that holds together if broken, useful for ground-floor security and safety in critical locations.
Like-for-like clear unit
A direct replacement matching the thickness and look of the original unit, for windows where no change in performance is needed.
Low-E upgrade unit
A coated pane and gas-filled cavity that reduce heat loss compared with older plain glass units, fitted in the same frame.
Misted Glass Repair in Aldershot: questions
Does misted double glazing lose heat?
A misted unit usually insulates less well than when it was new, because any insulating gas in the cavity has escaped and been replaced with damp air. The mist itself also reduces clarity. Replacing the unit restores a sealed cavity, and choosing a low-E unit can improve on the original performance where the old unit was plain glass.
Why has condensation appeared between my double glazing panes?
Condensation between the panes means the edge seal of the sealed unit has failed. Damp air has got into the cavity, and the drying agent in the spacer bar can no longer absorb it. The cause is often age, water sitting in the frame, poor packing or strong sun on the frame. The fix is to replace the sealed unit.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Do you cover Aldershot for misted glass repair?
Yes. We can quote for misted glass repair across Aldershot and the surrounding Hampshire area, including postcode districts GU11, and nearby Farnham, Farnborough and Fleet. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
More glazing in Aldershot
Misted Glass Repair nearby
Get a written quote in Aldershot
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.