Perth · Perth & Kinross
Misted Glass Repair in Perth
Is there fog between the panes of your windows in Perth? Our glaziers can confirm the seal has failed and quote for made-to-measure replacement units.
- PH2
- PH1
- Guide from £155
Foggy window replacement in Perth: what to know
A sealed unit has a spacer bar around its edge filled with desiccant, a drying agent that absorbs any moisture inside the cavity. When the edge seal fails, damp air keeps getting in until the desiccant is saturated, and condensation then forms between the panes where it cannot be wiped off.
Common causes of seal failure include water sitting in the frame rebate because drainage holes are blocked, units fitted without correct packers, strong sun on dark frames, and age. Clearing the drainage slots in the frame helps protect the new unit from the same problem.
Condensation on the room-side surface of the glass is not the same problem. It usually comes from humid indoor air meeting a cold pane and can be wiped away. Only mist trapped between the two panes means the sealed unit itself has failed and needs replacing.
Early seal failure often shows only on cold mornings or after rain and clears during the day. As the desiccant fills, the mist lasts longer and white mineral staining can form on the inner faces. Staining inside the unit cannot be removed by cleaning from either side.
What a typical job includes
- Removal of old units and cleaning of rebates
- Fitting on packers with drainage slots checked
- Made-to-measure replacement units matching your windows
- Survey to confirm the mist is inside the unit
Local details for Perth
- Postcodes covered
- PH2, PH1 and the surrounding area, including Kinross, Blairgowrie and Crieff
- Coast
- Perth sits roughly 9 km from the nearest coastline, close enough that exposure on open or high ground is worth considering. Salt air and wind-driven rain put extra strain on sealed unit edges in coastal homes. Keeping frame drainage clear and gaskets in good order matters more, and the glazier checks both so the replacement unit is not sitting in trapped water.
- Daylight and sun
- In Perth the midwinter sun reaches about 10° above the horizon at noon, with roughly 6.6 hours of daylight, rising to about 57° and 17.4 hours in midsummer. Units on sunny south and west elevations go through bigger daily temperature swings, which stresses the edge seal over time. In colder, darker months, mist between the panes is often most visible, so the survey is a good time to confirm failure.
- Access and setting
- Older rural homes may have timber frames or units of non-standard sizes, so careful measuring at the survey matters. Exposed sites with driving rain place more strain on seals, and the glazier checks frame drainage and bead condition before fitting.
- Rules in Scotland
- Section 4 (Safety) of the Scottish Technical Handbooks covers glazing that people could collide with, such as glass in and beside doors and low-level glazing, where safety glass is needed.
Guide prices in Perth
| Typical job | Guide price inc VAT |
|---|---|
| One misted unit, 600 × 900 mm | £155 – £195 |
| Two misted units, 600 × 900 mm | £305 – £395 |
| Four misted units, 600 × 1100 mm | £685 – £875 |
| Misted unit in a door, toughened | £305 – £385 |
Get a guide price for your size
Section 6 (Energy) of the Scottish Technical Handbooks sets the thermal performance that replacement windows, doors and rooflights should achieve.
What you can choose
Toughened safety unit
Both panes toughened, for misted units in doors, beside doors or low down where safety glass is required.
Georgian bar or leaded
Decorative bars or lead designs remade to match the originals so the new unit lines up with neighbouring windows.
Obscure glass unit
Patterned glass for bathrooms, landings and front doors, chosen to match existing obscure panes or to add privacy.
Misted Glass Repair in Perth: questions
Are misted units covered by a guarantee?
Often they are, for a period after installation. Many sealed unit manufacturers guarantee against misting, and the terms are set out in the paperwork from the original installer. If your units are still covered, contact that installer first. Units we supply carry manufacturer guarantees, and the terms are confirmed in writing with your quote.
How can I stop new sealed units misting early?
Keep the drainage slots at the bottom of the frame clear, so rainwater does not sit around the unit edges. Avoid pressure washing the seals, and do not paint over glazing gaskets. Check that opening sashes close properly, as a dropped sash can stress the unit. Report any cracked beads or failed gaskets early.
Can misted double glazing be fixed without replacing the window?
Yes. In most cases only the sealed unit needs replacing, not the frame. The glazier removes the beads, lifts out the misted unit and fits a new one made to the same thickness. Your frames, hinges, handles and locks stay as they are, provided they are in good condition, which the glazier checks at the survey.
How long does it take to replace a misted unit?
There are usually two visits. The first is a survey to measure each unit. The second is fitting, once the new units have been made to order. Fitting usually takes a short time per window, with little mess. Your quote sets out when the units are expected, and we will tell you honestly when a glazier can attend.
Do you cover Perth for misted glass repair?
Yes. We can quote for misted glass repair across Perth and the surrounding Perth & Kinross area, including postcode districts PH2 and PH1, and nearby Kinross, Blairgowrie and Crieff. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Perth
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.