Hatfield · Hertfordshire
Roof Lanterns in Hatfield
Old polycarbonate lanterns in Hatfield that leak, rattle or have yellowed can usually be replaced with a double glazed aluminium lantern on a sound upstand.
- AL9
- AL10
- Guide from £1,095
Roof lanterns across Hatfield
In England, a rooflight on a house is usually permitted development if it projects no more than 150mm beyond the roof plane and is no higher than the highest part of the roof. Raised lanterns often stand taller than that, so check with the council before ordering.
The Rooflight Association recommends laminated glass for the inner pane of glass rooflights, because laminated glass stays bonded together if it breaks instead of dropping fragments into the room below. Toughened inner panes are still used, but laminated is the safer choice over kitchens, stairs and seating areas.
A roof lantern is assembled from an aluminium ridge, hip bars and glazing bars that hold sealed glass units on each pitch. It sits on an upstand built around the roof opening. The upstand should be level, weathered into the roof covering and insulated, because a poor upstand causes most leaks and cold spots.
In England, Approved Document L sets a limiting U-value of 2.2 W/m²K for rooflights, calculated in the horizontal position, for both new and existing homes. A kerb or upstand built on site should achieve 0.35 W/m²K or better. Ask for the lantern's declared horizontal U-value, not a vertical figure.
What's included
- Sealed double glazed units with laminated inner pane options
- Removal and disposal of an old lantern or skylight
- Survey of the roof, opening, upstand and drainage
- Fixing, glazing and sealing onto the prepared upstand
About Hatfield for this job
- Postcodes covered
- AL9, AL10 and the surrounding area, including Welwyn Garden City, St Albans and Potters Bar
- Coast
- Hatfield is well inland, around 53 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Hatfield the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.5 hours of daylight, rising to about 62° and 16.5 hours in midsummer. Overhead glazing receives far more light than a wall window of the same size, especially when the sun is high in summer. South-facing lanterns may need solar-control glass, while low winter sun and north-facing rooms benefit from clear, high light-transmission low-E glass.
- Access and setting
- Rural roofs collect more leaves, moss and bird debris, so lanterns need clear upstand drainage and regular checks. Exposed sites see higher wind loads and driving rain, and older outbuildings may need the roof structure strengthening before a lantern is added.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Hatfield
| Typical job | Guide price inc VAT |
|---|---|
| Lantern 1500 × 1000 mm, fitted to a kerb | £1,395 – £1,795 |
| Lantern 2000 × 1000 mm | £1,695 – £2,095 |
| Lantern 3000 × 1500 mm | £2,795 – £3,695 |
| Flat glass rooflight 1000 × 1000 mm | £1,095 – £1,395 |
Get a guide price for your size
Listed buildings in England need listed building consent for most changes to historic windows or glass, and conservation areas can restrict changes visible from the street. Speak to the council's conservation officer before ordering.
Specification choices
Solar-control glass
Neutral or blue-tinted coatings that reduce heat build-up under south or west-facing lanterns while keeping daylight levels high.
Opening vents
Manual or electric vents in the lantern or skylight, with optional rain sensors that close them automatically in wet weather.
Square or octagonal lantern
A pyramid or eight-sided design that suits square rooms, orangeries and spaces where a central focal point is wanted.
Roof Lanterns in Hatfield: questions
What guarantee comes with a roof lantern?
Manufacturer guarantees apply to the frame, coating and sealed units, and the terms are confirmed in writing. The upstand and roof covering may be covered separately, depending on who builds them. Guarantee terms for the installation are set out in writing with your quote, so you know exactly what is covered before going ahead.
How long does it take to fit a roof lantern?
Fitting a roof lantern on a prepared upstand usually takes a day or less for a typical size, longer for large or complex shapes. The lantern is made to order first, and the lead time depends on its size, shape and colour. Building or rebuilding an upstand is separate roofing work that comes before fitting.
How much does a roof lantern cost?
The cost of a roof lantern depends on its size and shape, the glass specification, frame colour, any opening vents, and whether the upstand exists or needs building. Access to the roof and lifting a large lantern also affect labour. See the guide prices for typical ranges; the written quote fixes the price for your exact specification.
Will a roof lantern make my room too hot?
A roof lantern can add heat on sunny days, especially facing south or west, because overhead glass receives sun for much of the day. Solar-control glass, opening vents and blinds help keep the room comfortable. The glass is chosen at survey based on the lantern's size and orientation and how the room is used.
Do you cover Hatfield for roof lanterns?
Yes. We can quote for roof lanterns across Hatfield and the surrounding Hertfordshire area, including postcode districts AL9 and AL10, and nearby Welwyn Garden City, St Albans and Potters Bar. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Hatfield
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.