Hammersmith · Greater London
Safety Glass in Hammersmith
Is the glass in your doors in Hammersmith marked as safety glass? We can check and quote to replace it with toughened or laminated glass.
- SW6
- W6
- W12
- W14
- Guide from £55
Hammersmith: safety glass for doors
When measuring for a replacement panel, measure the opening or old glass in at least two places for width and height, and note the thickness. For anything with holes, curves or angled corners, a hardboard or card template gives the most reliable result.
Toughened glass is ordinary float glass that has been cut to size, heated and then cooled quickly with jets of air. This leaves the surfaces in compression, making it several times stronger than untreated glass of the same thickness. When it does break, it crumbles into small, relatively blunt pieces.
The price of safety glass depends on its size, thickness, whether it is toughened or laminated, the edge finish, the number of holes and cut-outs, any shapes or curves, and whether it is supplied only or fitted. Low-iron or tinted glass costs more than clear float.
Glass tabletops and shelves need the right thickness for the span and load. Thicker glass deflects less, so a long shelf or a large table needs a heavier panel than a small side table. The supplier confirms a suitable thickness for the use, not just the size.
What's included
- Glass cut, edge-worked and drilled before toughening
- Advice on toughened or laminated glass for the location
- Permanent safety marking on building glass
- Measurement or templating of the glass panel
About Hammersmith for this job
- Postcodes covered
- SW6, W6, W12, W14 and the surrounding area, including Shepherds Bush, Fulham and Kensington
- Coast
- Hammersmith is well inland, around 41 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Hammersmith the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Strong sun on large glass panels can cause glare and fade furniture behind them. Tinted, solar control or low-iron toughened glass each change how much light, heat and colour come through, so orientation is worth considering when choosing.
- Access and setting
- In flats and city buildings, large panels of safety glass may need to fit through narrow stairs, lifts and doorways. Measuring access routes at the survey avoids problems, and laminated glass suits ground-floor doors and screens facing the street.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Hammersmith
| Typical job | Guide price inc VAT |
|---|---|
| 6 mm toughened panel, 800 × 600 mm | £55 – £75 |
| 10 mm toughened panel, 1000 × 2000 mm | £325 – £415 |
| Glass tabletop or shelf, 1200 × 600 mm, 8 mm | £135 – £165 |
| 6.4 mm laminated panel, 900 × 900 mm | £115 – £145 |
Get a guide price for your size
Approved Document Q applies to new homes in England, where doors and windows are expected to meet PAS 24 or an equivalent standard. It does not apply to replacements in existing homes, but PAS 24 products are still a sensible choice.
Specification choices
Low-iron glass
Extra-clear glass with much less green tint, chosen for tabletops, shelving and panels where colour and edge clarity matter.
Laminated safety glass
Two or more sheets bonded with an interlayer that holds broken glass in place, for overhead, security and fall-risk locations.
Satin or obscure finish
Acid-etched or patterned glass for privacy in doors and screens, toughened or laminated to meet safety requirements.
Safety Glass in Hammersmith: questions
Should I choose a polished or arrised edge?
Choose polished edges where the edge will be seen or touched, such as tabletops, shelves and frameless panels, because they are smooth and look neat. Arrised edges are lightly sanded to remove sharpness and are fine where the edge sits hidden in a frame. Bevelled edges are decorative and suit mirrors and some tabletops.
Where is safety glass required in a house?
In England, safety glass is needed in critical locations: glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Small panes and leaded lights have specific exceptions. The rules elsewhere in the UK are similar, but the detail differs between nations.
What thickness of toughened glass do I need for a table or shelf?
It depends on the size, how the glass is supported and the load it will carry. Small side tables can use thinner glass, while large dining tables and long shelves need thicker panels to limit bending. Tell us the dimensions, support method and what it will hold, and we will confirm a suitable thickness in the quote.
Is laminated glass better for security?
Laminated glass usually gives better security than toughened glass of similar thickness, because the interlayer holds the glass together after it cracks, so making a hole takes more effort. Thicker interlayers and multi-layer laminates give more resistance. For ground-floor windows, shopfronts and doors, laminated glass is often chosen for this reason.
Do you cover Hammersmith for safety glass?
Yes. We can quote for safety glass across Hammersmith and the surrounding Greater London area, including postcode districts SW6, W6, W12 and W14, and nearby Shepherds Bush, Fulham and Kensington. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Hammersmith
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.