Putney · Greater London
Replacement Glass in Putney
Need new glass for a window or door in Putney? We cover replacement sealed units, safety glass and obscure glass for existing uPVC, aluminium and timber frames.
- SW15
- SW6
- SW18
- Guide from £135
Replacement window glass across Putney
Acoustic laminated glass uses a special interlayer that dampens sound passing through the pane. Using two different glass thicknesses in a sealed unit also helps, because each pane resonates at a different frequency. Both can be fitted in an existing frame, though the frame and its seals also affect how much noise gets through.
Older sealed units often have plain float glass on both sides. A replacement unit can use a low-emissivity coated pane and a gas-filled cavity, which reduces heat loss through the glass without changing the frame. The coating faces into the cavity and is not noticeable in normal use.
Many modern windows are internally beaded, which makes it harder to remove glass from outside. If your windows have external beads, ask about security glazing tape or clips when the glass is replaced, as these make it more difficult for beads to be prised off from outside.
Units with Georgian bars or leaded designs can be remade to match the originals. The glazier notes the bar width, colour and layout, or the lead pattern, so the new unit lines up with neighbouring windows. Bars fitted inside the cavity are protected from dirt and need no separate cleaning.
What a typical job includes
- Fitting on glazing packers with the beads refitted
- Removal of old glass and packaging from site
- Survey and measurement of the existing glass or unit
- Written quote fixing the price for the specification
Working in Putney
- Postcodes covered
- SW15, SW6, SW18 and the surrounding area, including Wandsworth, Barnes and Fulham
- Coast
- Putney is well inland, around 40 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Putney the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. On south and west elevations, a solar control or low-E coating changes how much heat and glare new glass lets in. North-facing rooms usually benefit more from glass that keeps heat in while admitting as much daylight as possible.
- Access and setting
- In towns and cities, replacing glass in flats or above shops often means planning parking, stair access and lifting large units safely. Laminated glass suits ground-floor windows, acoustic glass helps on busy roads, and conservation areas may need matching patterns.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Putney
| Typical job | Guide price inc VAT |
|---|---|
| Small double glazed unit, 500 × 700 mm | £135 – £175 |
| Standard unit, 600 × 900 mm | £165 – £205 |
| Large unit, 1200 × 1200 mm | £285 – £365 |
| Toughened unit for a door, 750 × 1800 mm | £345 – £435 |
| Triple glazed unit, 600 × 900 mm | £235 – £305 |
Get a guide price for your size
Approved Document L sets the minimum energy performance for replacement windows and doors in existing homes in England: a U-value of 1.4 W/m²K, or Window Energy Rating band B for windows; doors can instead meet a Door Set Energy Rating (band B, or band C for doors more than 60% glazed); rooflights need 2.2 W/m²K.
Specification choices
Toughened safety glass
Heat-treated glass that breaks into small, relatively blunt pieces, used in doors, low-level panes and other critical locations.
Triple glazed unit
Three panes and two cavities for extra insulation, where the frame's rebate is deep enough to take the thicker unit.
Georgian bar or leaded unit
Decorative bars or lead designs inside or on the glass, matched to existing windows for a consistent look across the property.
Replacement Glass in Putney: questions
Do I need safety glass in my replacement window?
You do if the glass is in a critical location. In England, that means glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Elsewhere in the UK the rules are similar, but the detail differs between nations. The glazier checks each location at the survey.
Should I upgrade to low-E glass when replacing a unit?
If the existing unit is plain float glass, a low-emissivity unit is worth considering because it reduces heat loss through the glass and keeps the inner pane warmer, which can reduce condensation on the room side. It fits the same frame, provided the overall thickness matches. The quote can show standard and low-E options side by side.
Does replacing window glass need building regulations approval?
Replacing only the glass in an existing frame is normally treated as a repair in England and does not need to be notified. Replacing the whole window is different and must go through building control or a competent person scheme. Even for glass-only work, safety glass should be used in critical locations, and the detail of the rules differs between UK nations.
Can I replace a sealed unit myself?
Single panes in simple frames are sometimes replaced by confident DIYers, but sealed units and safety glass carry risks. A unit that is not packed correctly can make an opening sash drop or crack under load, and handling large panes is hazardous. A glazier also checks whether safety glass is required and that the new glass carries the correct marking.
Do you cover Putney for replacement glass?
Yes. We can quote for replacement glass across Putney and the surrounding Greater London area, including postcode districts SW15, SW6 and SW18, and nearby Wandsworth, Barnes and Fulham. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Putney
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.