Reigate · Surrey
Safety Glass in Reigate
Is the glass in your doors in Reigate marked as safety glass? We can check and quote to replace it with toughened or laminated glass.
- RH2
- RH1
- RH3
- Guide from £55
Safety glass for doors across Reigate
When measuring for a replacement panel, measure the opening or old glass in at least two places for width and height, and note the thickness. For anything with holes, curves or angled corners, a hardboard or card template gives the most reliable result.
Glass tabletops and shelves need the right thickness for the span and load. Thicker glass deflects less, so a long shelf or a large table needs a heavier panel than a small side table. The supplier confirms a suitable thickness for the use, not just the size.
Laminated glass is two or more sheets bonded with a plastic interlayer, often PVB. If it breaks, the pieces stick to the interlayer and the pane stays in place. That makes it useful for overhead glass, ground-floor security and openings where an empty hole would be a risk.
Toughened glass can, in rare cases, break without any obvious impact because of tiny nickel sulphide inclusions in the glass. Heat soak testing exposes the toughened glass to heat for a set period to break susceptible panes before supply, which reduces the risk without removing it completely.
What a typical job includes
- Glass cut, edge-worked and drilled before toughening
- Delivery or fitting by our glaziers
- Permanent safety marking on building glass
- Written quote fixing the price for the specification
Reigate at a glance
- Postcodes covered
- RH2, RH1, RH3 and the surrounding area, including Redhill, Horley and Banstead
- Coast
- Reigate is well inland, around 45 km from the nearest coast, so salt exposure is not usually a factor.
- Daylight and sun
- In Reigate the midwinter sun reaches about 15° above the horizon at noon, with roughly 7.6 hours of daylight, rising to about 62° and 16.4 hours in midsummer. Strong sun on large glass panels can cause glare and fade furniture behind them. Tinted, solar control or low-iron toughened glass each change how much light, heat and colour come through, so orientation is worth considering when choosing.
- Access and setting
- Older rural homes often have internal doors and screens with old, unmarked glass. Upgrading them to toughened or laminated safety glass is common, and timber door frames may need careful beading when the new glass is fitted.
- Rules in England
- Approved Document K requires safety glass in critical locations in England: glazing in doors and in side panels within 300 mm of a door, up to 1500 mm above floor level, and any glazing in walls or partitions up to 800 mm above floor level.
Guide prices in Reigate
| Typical job | Guide price inc VAT |
|---|---|
| 6 mm toughened panel, 800 × 600 mm | £55 – £75 |
| 10 mm toughened panel, 1000 × 2000 mm | £325 – £415 |
| Glass tabletop or shelf, 1200 × 600 mm, 8 mm | £135 – £165 |
| 6.4 mm laminated panel, 900 × 900 mm | £115 – £145 |
Get a guide price for your size
Approved Document Q applies to new homes in England, where doors and windows are expected to meet PAS 24 or an equivalent standard. It does not apply to replacements in existing homes, but PAS 24 products are still a sensible choice.
Options to choose between
Clear toughened glass
Heat-treated float glass that breaks into small, blunt pieces, for doors, screens, tabletops and shelves in a range of thicknesses.
Low-iron glass
Extra-clear glass with much less green tint, chosen for tabletops, shelving and panels where colour and edge clarity matter.
Holes and cut-outs
Drilled holes for handles, hinges and fixings, and cut-outs for sockets, all made before the glass is toughened.
Safety Glass in Reigate: questions
What is the difference between toughened and laminated glass?
Toughened glass is heat treated so it is stronger and, if broken, crumbles into small, relatively blunt pieces, leaving the opening empty. Laminated glass is sheets bonded to an interlayer, so when it breaks the pieces stay stuck in place. Both can be safety glass. Laminated is preferred where falling glass or an open hole would be a hazard.
Where is safety glass required in a house?
In England, safety glass is needed in critical locations: glass in doors and within 300mm of a door edge, up to 1500mm above floor level, and other glass within 800mm of the floor. Small panes and leaded lights have specific exceptions. The rules elsewhere in the UK are similar, but the detail differs between nations.
Can toughened glass break on its own?
Rarely, yes. Tiny nickel sulphide inclusions in the glass can expand over time and cause a toughened pane to break without an obvious impact. Edge damage during fitting can also cause later failure. Heat soak testing reduces the risk of inclusion-related breakage, and careful handling and correct fitting protect the edges.
Is laminated glass better for security?
Laminated glass usually gives better security than toughened glass of similar thickness, because the interlayer holds the glass together after it cracks, so making a hole takes more effort. Thicker interlayers and multi-layer laminates give more resistance. For ground-floor windows, shopfronts and doors, laminated glass is often chosen for this reason.
Do you cover Reigate for safety glass?
Yes. We can quote for safety glass across Reigate and the surrounding Surrey area, including postcode districts RH2, RH1 and RH3, and nearby Redhill, Horley and Banstead. Start with your postcode on the quote form and a glazier will arrange a free survey before giving you a written quote.
Get a written quote in Reigate
Free survey for new glazing, clear guide prices and one point of contact for every glazing job.